Where can I get the MIBS for HWIC-4ESW-POE= and the HWIC-D-9ESW-POE?
Customer is using Openview NNM to monitor the Cisco devices.
Customer requires to find the appropriate MIB descriptions to be used to monitor ONLY the FastEthernet module. So if the module for some reason stops functioning he will receive the appropriate failure alerts.
HWIC-4ESW-POE= and the HWIC-D-9ESW-POE
in Cisco 2800 routers are the ones I am talking about.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...