01-20-2008 08:31 PM - edited 03-05-2019 08:35 PM
In a Cisco 7206VXR router that has a NPE-300 and and I/O controller I undertand that the IOS is on a PCMCIA card which is installed on the I/O controller. Is the config also held on the I/O controller or is it held on teh NPe-300. When we put a NPE-G1 I understand that an I/O controller is not required and that the the IOS and config are held on NPE-G1.
To ask the question in another way - If we replace the NPE-300 module does the startup config need to be loaded into the new NPE-300?
01-20-2008 10:56 PM
I believe the NVRAM is stored on the I/O Controller on all NPEs except the G1 and G2.
01-20-2008 10:57 PM
This is related to the uBR7200, but for the most part it is the same architecture.
http://www.cisco.com/en/US/tech/tk86/tk804/technologies_tech_note09186a0080204a1a.shtml#io_board
01-21-2008 02:13 AM
Thanks for the info and pointers
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: