Im putting the command the below command for limiting the trafficon my interface .I have both IPv4 and IPv6 both enabled on the interface .Whether the class-default will match IPv6 packets also ??What are the things matched by class class-default ?
policy-map test class class-default shape average 8192000
interface GigabitEthernet6/1.132 ip address 126.96.36.199 255.255.255.0
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...