Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Which command is able to display interfaces' IP address, status and uptime?

Which command is able to display interfaces' IP address, status and uptime?

Thanks for help.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Which command is able to display interfaces' IP address, sta

The command: show ip interface brief will show the interface name, it's IP address, when the IP was set (boot time, or by config) it's current physical and logical status.

And I don't know about uptime, but the command: show interfaces link will show how long a physical interface has been down.

5 REPLIES
Bronze

Re: Which command is able to display interfaces' IP address, sta

The command: show ip interface brief will show the interface name, it's IP address, when the IP was set (boot time, or by config) it's current physical and logical status.

And I don't know about uptime, but the command: show interfaces link will show how long a physical interface has been down.

New Member

Re: Which command is able to display interfaces' IP address, sta

Thanks for help

New Member

Re: Which command is able to display interfaces' IP address, sta

router#show logging

Will show you a history of all interfaces and the UP DOWN status.

you might want to increase the log size to get more keep more information

router#logging buffered 4096 errors

Blue

Re: Which command is able to display interfaces' IP address, sta

John:

You may want to reconsider your advice.

Executing a "sh log" will not give you any interface status and configuration information at all.

Yes, if an interface happened to go down or come back up, there will be an indication in the log. But that is hardly a reasonable way to go about getting interface information.

HTH

Victor

Silver

Re: Which command is able to display interfaces' IP address, sta

take a look at:

show interfaces status

looks quite useful imo.

hth,

Ajaz

215
Views
4
Helpful
5
Replies