When I look at my syslogs on my 4006 switch, the events that are logged look like they have the correct time on them. If I go in and do a config t and then back out and look at the syslog, the timestamp on the new entry is incorrect. Any ideas?
Dec 5 06:06:38: %RCMD-4-RSHPORTATTEMPT: Attempted to connect to RSHELL from 10.200.206.7
Dec 5 14:36:51: %SYS-5-CONFIG_I: Configured from console by pfeffes on vty0 (10.200.15.24)
Dec 5 14:39:30: %SYS-5-CONFIG_I: Configured from console by pfeffes on vty0 (10.200.15.24)
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...