Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Why did my 3560-E reboot?

Is there a show command that would show why the system restarted. Specifically if it was restarted by a user from the cli. I thought a show version used to tell you this, but I don't see it now.

5 REPLIES
Bronze

Re: Why did my 3560-E reboot?

cisco WS-C3750-24P (PowerPC405) processor (revision J0) with 118784K/12280K bytes of memory.

Processor board ID CAT1030ZHB9

Last reset from power-on ----- This??

1 Virtual Ethernet interface

48 FastEthernet interfaces

4 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

New Member

Re: Why did my 3560-E reboot?

No, that appears if the power was unplugged or the system was restarted via CLI. I thought there used to be something more. Something like "system reload via system-restart command".

Bronze

Re: Why did my 3560-E reboot?

Syslogs should show:

*Mar 1 00:16:21.148: %SYS-5-RELOAD: Reload requested by console. Reload reason: Reload command

If you are using TACACS+, command history/accounting would also show you this.

Bronze

Re: Why did my 3560-E reboot?

It might show in your device logs also.

Re: Why did my 3560-E reboot?

408
Views
0
Helpful
5
Replies