Why does telnet still work on 3560?

[JohnDough123]

I have enabled/configured SSHv2 - it works fine.

Can ssh in from a remote location.

Configured vty 0 4 for ssh only (took telnet out).

Did copy run start & write mem.

Also did a reload to boot the switch from scratch.

But telnet still works. Why?

Here are the salient parts of the config.....

line con 0

line vty 0 4

password 7 082058420017

transport input ssh

line vty 5 15

password 7 092078432217

Any other parts of the config I should include?

Thx Gurus.

[Marvin Rhoads · Accepted solution]

Your "line vty 5 15" section leaves telnet available for that second group of vty lines. Just add "transport input ssh" there as well and you should be good to go.

[JohnDough123]

Thx Marvin - now - connection refused via telnet.

Yippeeeeee!

[Marvin Rhoads]

You're welcome. Thanks for the rating.