Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Why does telnet still work on 3560?

I have enabled/configured SSHv2 - it works fine.

Can ssh in from a remote location.

Configured vty 0 4 for ssh only (took telnet out).

Did copy run start & write mem.

Also did a reload to boot the switch from scratch.

But telnet still works. Why?

Here are the salient parts of the config.....

line con 0

line vty 0 4

password 7 082058420017

transport input ssh

line vty 5 15

password 7 092078432217

Any other parts of the config I should include?

Thx Gurus.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Why does telnet still work on 3560?

Your "line vty 5 15" section leaves telnet available for that second group of vty lines. Just add "transport input ssh" there as well and you should be good to go.

3 REPLIES
Hall of Fame Super Silver

Why does telnet still work on 3560?

Your "line vty 5 15" section leaves telnet available for that second group of vty lines. Just add "transport input ssh" there as well and you should be good to go.

New Member

Why does telnet still work on 3560?

Thx Marvin - now - connection refused via telnet.

Yippeeeeee!

Hall of Fame Super Silver

Why does telnet still work on 3560?

You're welcome. Thanks for the rating.

165
Views
0
Helpful
3
Replies