cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1905
Views
0
Helpful
1
Replies

Why is my 3750 switch have a configuration register of 0xF?

FRANK CAPOZZA
Level 1
Level 1

I am uploading new configurations to my Cisco 3750 stacked switch and noticed that after the load I cannot log back into the switch because my password somehow was changed. After performing password recovery and getting back into the swtch, I noticed the configuration register was 0xF. I have never seen this before. The config-register command does not seem to be supported to change it back to factory default. The switch is on a ship which has several power hits when they switch power from shore to ship power.Can this cause the configuration register to change? What is the best way to change the configuration register?

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame
After performing password recovery and getting back into the swtch, I noticed the configuration register was 0xF. I have never seen this before

0xF is normal.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: