Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WIC 2T Inter Connectivity Problem

Hi

Basically I am facing a problem where I have this setup:-

                          DTE      HQ     DCE  ( s0/1/1  "admin down" 192.168.9.161 )

                                      /         \

                          ok    /             \    x

                                  /                 \

        DCE     Branch1              Branch2    DTE   ( s0/1 "down" 192.168.9.190 )

The connection btwn HQ & Branch2 has failed !!!

Branch 2 & HQ has all the clocking64k(DCE only), bandwidth56k, no shutdown, ip addresses (subnets)  set properly.

These are WIC 2T (smart serial) connections.

Br 2  &  HQ  flash up on/off   during boot. But lights fail to show after router initialisation complete.

I have checked all WIC 2T cards & replaced with new ones. Used new cables too.

HQ is a cisco 1841 advanced IP services security Router. (SDM)

Branch 1 & 2 are old cisco 2620 routers.

I will give you further info in the attachments. Such as Admin Down/ Down  / sh ip int brief / sh run/ sh interface

If you can help. I thought it was how the bandwidth/ clockrate cmd was worded/ written on each different router.

Any insight is invaluable:   baljitsingh@talktalk.net

How many WIC2T cards are allowed on a 1841 router? I have tried 2 WIC 2T cards i am prsently with & 1 WIC2T card.

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

WIC 2T Inter Connectivity Problem

On the HQ router s0/1/1 is shut can you do a no sh and try again?

also, what is the output of sh cont int s0/0/1?

HTH

2 REPLIES
VIP Super Bronze

WIC 2T Inter Connectivity Problem

On the HQ router s0/1/1 is shut can you do a no sh and try again?

also, what is the output of sh cont int s0/0/1?

HTH

New Member

Re: WIC 2T Inter Connectivity Problem

Thanks so much. That worked ! Wow ! I am so thankful.

Also add me on as a contact/ friend on LinkedIn   "Baljit Singh"  or   "Baljit Singh Passan"

email: baljitsingh@talktalk.net

Appreciate your insight.

Message was edited by: Baljit Singh Passan

688
Views
0
Helpful
2
Replies