Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Will 'no switch x provision' cause switch to reload ?

Hi there

I have inherited a switch stack as follows:

Switch#  Role   Mac Address     Priority Version  State
----------------------------------------------------------
*1       Master 04fe.7f0d.2280     1      0       Ready              
2       Member 0000.0000.0000     0      0       Provisioned        
3       Member ec44.76e5.7980     1      0       Ready              
4       Member 0064.40aa.2200     1      0       Ready             

UK01SW47#sh swi stack-p
  Switch #    Port 1       Port 2
  --------    ------       ------
    1          Down          Ok  
    3           Ok           Ok  
    4           Ok          Down

UK01SW47#sh swi nei
  Switch #    Port 1       Port 2
  --------    ------       ------
      1        None           3 
      3         4             1 
      4         3            None

I need to remove switch 1 and just stack the current switch 3 & 4.

I intend to

     a: power off switch 1. This should cause a master election between 3 & 4.

     b: connect stack cable between switch 3 port 2 and switch 4 port 2 to enable a full duplex redundant connection.

I would like to remove switch 1 and 2 from the configuration with:

no switch 2 provision ws-c3750g-48ts

no switch 1 provision ws-c3750g-48ts

Will this cause the switch stack to reload.

As this is a production system I hope it wont

Thanks for you expected help

Regards

Richard

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Will 'no switch x provision' cause switch to reload ?

Hi Richard,

You should be good. The switch stack should not reload after removing the two unprovisioned switches.

http://www.cisco.com/en/US/partner/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#stack6

JayaKrishna

2 REPLIES
Cisco Employee

Re: Will 'no switch x provision' cause switch to reload ?

Hi Richard,

You should be good. The switch stack should not reload after removing the two unprovisioned switches.

http://www.cisco.com/en/US/partner/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#stack6

JayaKrishna

Hall of Fame Super Gold

Re: Will 'no switch x provision' cause switch to reload ?

Sure but switch numbering will be puzzling to the un-initiated.

2950
Views
0
Helpful
2
Replies
CreatePlease to create content