I have a 3750 switch that supports several VLANs. Right now the DHCP for the various VLANs is being done by the switch itself. I would like to move the DHCP service to a Windows server that does not support VLANs. How can I do this? I figure I need some type of "ip helper" command but how would I account for the different VLANs if the Windows server is not VLAN aware? Do I have to VLAN enable the server?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...