Hi, i have a problem with my aironet 1231 access point. i have ssids mapped to vlans which have static wep keys- however i created an ssid which has no security and mapped it onto a vlan i want to use for internet access only. problem is that on the configuration webpage it shows the ssid as having no security but when i try to connect through a client pc, the ssid is shown to have a wep key. how do i sort this out, i have tried reconfiguring it but after a while it reoccurs. has anyone seen this before?
When the access point configuration is at factory defaults, the first SSID that you create using the Express security page overwrites the default SSID, tsunami, which has no security settings. The SSIDs that you create appear in the SSID table at the bottom of the page. You can create up to 16 SSIDs on the access point. On dual-radio access points, the SSIDs that you create are enabled on both radio interfaces.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...