I have a pix firewall to connect some hosts from internet to enteprise intranet.
The pix is conencted to ADSL modem and one cisco switch. The hosts will be connected to the switch and then will receive ip address from the pix. I want to connect one AP 1100 aironet to the switch for wireless clients but i have one problem here! The wireless will receive one ip address for bvi interface and i must create one radius account on the ACS server for radius athentication, the radius server is on the intranet side. I can not control the pix and the scope of ip addresses that i get from the enteprise, but i can control the ACS server and the 1100 AP. Can i have the AP with dynamic ip on the bvi interface and set one static address to create the radius account on the ACS server? With vlans? But how can i use trunks with the pix as firewall? The ACS and pix are different subnets/vlans
The Dynamic Host Configuration Protocol (DHCP) daemon must be enabled to listen for DHCP client requests. When the PIX Firewall acts as a DHCP server, PIX provides network configuration parameters to DHCP clients. You cannot configure DHCP reservation on PIX.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...