Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WISM requirements for VSS

Hi all,

I have the following on my 6509:

Mod  Port Model              Serial #    Versions

---- ---- ------------------ ----------- -------------------------------------

  1   10  WS-SVC-WISM-1-K9   XXXXXXXXXXX Hw : 2.2

                                         Fw : 12.2(14r)S5

                                         Sw : 12.2(18)SXF16

                                         Sw1: 8.6(0.306)R3V39

          WS-SVC-WISM-1-K9-D XXXXXXXXXXXX Hw : 2.1

There are few documents that tell me different requirements for the WISM cards to configure VSS. Please give me some guidelines of what I need to do.

Thank you,

Tuan

1 REPLY
New Member

WISM requirements for VSS

In this document it says the minimum requirement is version 3.2 but the example they use are 2.2 and 2.1:

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a0080a6c202.shtml

226
Views
0
Helpful
1
Replies