Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLANS

Hi all, if I have a wlan and I want to have different vlans within this, Do I just create vlans on my switches, and then does the wlan controller have ports I can plug into each of these vlans ? and If I wanted to route between them, would I just enabled ip routing on the switch ?

2 REPLIES
New Member

Re: WLANS

Create your VLANs on your switch,

Create the same VLANs on your access points/bridges

Connect AP or bridge to switch in dot1q trunking mode - this will pass all VLANs between the two.

Use layer 3 switch to route between VLANs.

SSIDs map to VLANs, VLANs map to whatever security you need per SSID/VLAN.

Randy

New Member

Re: WLANS

Hi there, cheers for that, would I have to use a trunk link to my wlan controller also ?

127
Views
0
Helpful
2
Replies