Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC4404 does'nt accept more then 48 AP's, but have license 100 AP's

Hello everybody,

I have a problem with my wireless controller.

Somehow it will not add more AP's then 48, i have a license for 100 AP's.

Is there a setting then can have been changed.

Now the other access points (15) are associating with the wrong WLC.

even if i reboot the other controller the access point should fall back to this controller but they do not associate and numbers of AP's stay at 48.

(Maximum number of APs supported                   100)

Thank you in advanced.

Everyone's tags (1)
1 REPLY
New Member

WLC4404 does'nt accept more then 48 AP's, but have license 100 A

Already found the problem but thanks anyway.

Choosing Between Link Aggregation and Multiple AP-Manager Interfaces

Cisco 4400 Series Controllers can support up to 48 access points per  port. However, you can configure your Cisco 4400 Series Controller to  support more access points by using link aggregation (LAG) or  configuring dynamic AP-managers on each Gigabit Ethernet port

171
Views
0
Helpful
1
Replies