Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

Hi All,

Someone please clarify if we can etherchannel between WS-C2948G-GE-TX (cat OS) and 3560G-24TS (IOS). It sounds like 'YES' but just want to get openion from gurus..:-)

Thank you in advance

MS

6 REPLIES
Purple

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

Yes you can etherchannel between the two .

2948

set port channel slot/port desirable non-silent

3560

on the interface

channel-group X mode desirable non-silent

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

Hi,

Thank you for your reply and apologies for the delay in getting back. So I used the link

http://www.cisco.com/en/US/products/hw/switches/ps672/products_configuration_example09186a00801258ff.shtml#gshow

and current config...(using 2/1 & 2/2 for port-channel)

set port channel 2/1-2 10

set trunk 2/1 nonegotiate dot1q

set trunk 2/2 nonegotiate dot1q

(by default it allows all Vlans).

The port 2/1 & 2/2 were initially set for Vlan771 than 1(that we created). I have not made any connections to other switch, but the o/p:

sh trunk:

Test-2948-S1> (enable) sh trunk

No ports trunking.

TEST-2948-S1> (enable) sh port channel

Port Status Channel Mode admin Group

----- ---------- -------------------- ----- --

2/1 notconnect on 10 417

2/2 notconnect on 10 417

Sh port 2/1

Port Name Status Vlan Duplex Speed

----- ------------------ ---------- ----------

2/1 Test notconnect 771 auto auto

Same with 2/2 also (not showing Trunking)

Do I need to move the ports 2/1 & 2/2 to Vla1 before enable trunking..? or the Trunk pops up when I connect the other switch ports?

Thank you

MS

Hall of Fame Super Bronze

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

The trunk will form once the ports become up/up after being connected to another switch.

HTH,

__

Edison.

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

So the Switch ports (2/1 & 2/2) currently showing being members of VLA771 at this time does not matter. Thank you for the reply Edison. Will post how it goes.

Thank you

MS

Hall of Fame Super Bronze

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

When the switch isn't connected and it's configured as trunked, it will list being a member of its native Vlan.

HTH,

__

Edison.

Re: WS-C2948G-GE-TX <--Etherchannel--> 3560G-24TS

Everything Looks good.

Thank you

MS

470
Views
5
Helpful
6
Replies
CreatePlease to create content