WS-C2950-24 EtherChannels setup for Intel(R) PRO/1000 MT Dual Port NICs
I have a WS-C2950-24. I want to setup an EtherChannel of 2 ports. Those ports are connected to 2 Intel(R) PRO/1000 MT Dual Port of a Microsoft Windows Server 2003 Standard Edititon SP1 (OEM). The hardware is an Xtore WSS NAS (XN-104R-T2SP) (see http://www.xtore.com/product_Detail.asp?id_cat=1&id=13). How do I setup the Intel NICs with driver version188.8.131.52 for Express Teaming to comply with the Cisco EtherChannels.
Re: WS-C2950-24 EtherChannels setup for Intel(R) PRO/1000 MT Dua
Thanks for the reply.
I have to admid I'm new in these things and telnet sessions are replaced by the beautifull Cisco Network Assistant app. Running via Parallell's Desktop Windows XP Pro SP2 on MacBook Pro 10.4.8
The struggle I have in with the Intel NICs is that only in the Advanced Properties of the NIC's I can get to Teaming. That's why the driver version as mentioned is the only one that is offering this. In literature on this I read about the Intel proset but have failed to visualise it in any interface on Windows. Perhaps the hardware I'm using (Xtore NAS) is prohibiting the use of this??
So in the Advanced Props I have:
Adaptive inter-Frame Spacing, Enable PME, Express Teaming, Flow Control, Interrupt Moderation Rate, Jumbo Frames, Link Speed & Duplex, Locally Administered Address, Log Link State Event, Offload Receive IP Checksum, Offload Receive TCP Checksum, Offload TCP Segmentation, Offload Transmit IP Checksum, Offload Transmit TCP Checksum, QoS Packet Tagging, Receive Descriptors, Transmit Descriptors, Wait for Link, Wake On Link Settings and Wake On Settings.
Can you indicate how these should be set to comply with LACP Team with VLAN 10 Tagging?
Also much appreciated is the translation of your telnet commands into CNA. eg. I have created an EtherChannel on port Fa0/18 and Fa0/19, Mode = LACP, Priority is 32768; Load Balance is set to Source MAC address... Then I'm lost.
Just follow these on the command prompt, "hostname" will be whatever your switches name is and make sure the syntax for the Interface XXXXXXX is correct. Make sure you have the proper vlan that the server will be in.
You need to download the IntelProset complate driver package. All you have installed is the driver, there is more to it than that. When you download it, extract it and run the exe to install it. Then there is a wizard for creating teaming. Simple.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...