Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WS-C3550-48-SMI - Config.

Hi, I have a WS-C3550-48-SMI switch and am wanting to do a redundant switch configuration.

I am looking to  go for an active / active HSRP configuration using one additional switch rather than chassis based.

Has anybody done this before and have any pointers?

  • LAN Switching and Routing
Everyone's tags (9)
1 REPLY
Silver

Re: WS-C3550-48-SMI - Config.

Hi,

Since it's difficult to tell what would be the best solution for your network as every network is different, I'd encourage you to check the following guides for more details and examples about HSRP.

Using HSRP for Fault-Tolerant IP Routing

http://www.cisco.com/en/US/docs/internetworking/case/studies/cs009.html

Hot Standby Router Protocol (HSRP): Frequently Asked Questions

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_q_and_a_item09186a00800a9679.shtml

Hot Standby Router Protocol Features and Functionality

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a91.shtml

Configuring HSRP on Catalyst 3550 Switches

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.2_44_se/configuration/guide/swhsrp.html

Andras

1127
Views
0
Helpful
1
Replies
This widget could not be displayed.