Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-C3650-24TS-S Switching Capacity

Hi all.

WS-C3650-24TS-S's switching capacity is 88Gbps in datasheet. (http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3650-series-switches/data_sheet_c78-729449.html?cachemode=refresh)

 

But, I don't know this capacity to full-duplex or half-duplex.

 

I want know C3650's switching capacity with duplex.

 

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Cisco generally quotes switch/fabric capacity as full duplex.

As the -24TD supports dual 10g, you have 24g ports + two 10g = 44g or 88g duplex.

You -24TS is built on the same fabric, but only needs (28g ports) 56g.

2 REPLIES
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Cisco generally quotes switch/fabric capacity as full duplex.

As the -24TD supports dual 10g, you have 24g ports + two 10g = 44g or 88g duplex.

You -24TS is built on the same fabric, but only needs (28g ports) 56g.

New Member

Thanks for your reply. :) 

Thanks for your reply. :)
 

567
Views
0
Helpful
2
Replies
CreatePlease login to create content