cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
379
Views
0
Helpful
2
Replies

WS-C3750G-12S-S - identify the fault

lunarsystems
Level 1
Level 1

Hi there,

I'm having trouble booting up the WS-C3750G-12S-S switch.

When I power up the swith, it boots and then just always stops at the same point. It does not allow me to type anything or does not react to any input at all.

Please see the attachment showing the output.

Does anyone know what may be causing this?

Thanks

Andrei

2 Replies 2

Prashanth Krishnappa
Cisco Employee
Cisco Employee

What does the LED state indicate? I would say open a TAC case and get it replaced.

SYST, MASTR and STAT LEDs stay green.

So, I guess it does not indicate there is a hardware fault.

Also, it allows me to go into the ROMMON mode and delete all config files, but when I enter 'boot' it boots and then stops at exact same point again.

Could it be a corrupted IOS image?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: