Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-C4507RE+96V+ with redundant supervisor

Hi,

When I have a C4507 as below (I am thinking about adding a second SUP7L) is it possible to use the 10G ports of both supervisors at the same time?

I will need 4 x 10G ports and because each suppervisor has 2 x 10G I was wondering if I would be able to use the four ports at the same time.

WS-C4507RE+96V+WS-C4507R+E Chassis, two WS-X4648-RJ45V+E,   Sup7L-E, LAN Base1
WS-X45-SUP7L-E/2Catalyst 4500 E-Series Supervisor LE, 520Gbps redundant1
WS-X45-SUP7L-ECatalyst 4500 E-Series Supervisor LE, 520Gbps1



Any help is much appreciated.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

WS-C4507RE+96V+ with redundant supervisor

Hi Juan,

you can use in total 4 10 gig ports from the two SUP modules. As per the configuration document:

When you use WS-X45-SUP7-E in RPR or SSO mode, only the first two uplinks on each supervisor engine are available. The second two uplinks are unavailable.

On top of that, you can view the datasheet (High-Availability and Uplink Options for Supervisor Engine 7-E section) and you will see other options of using 10gig & 1gig link on these uplink ports.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/data_sheet_c78-612364.html

Hope this the above information helps.

Neeraj

2 REPLIES

WS-C4507RE+96V+ with redundant supervisor

Hi Juan,

you can use in total 4 10 gig ports from the two SUP modules. As per the configuration document:

When you use WS-X45-SUP7-E in RPR or SSO mode, only the first two uplinks on each supervisor engine are available. The second two uplinks are unavailable.

On top of that, you can view the datasheet (High-Availability and Uplink Options for Supervisor Engine 7-E section) and you will see other options of using 10gig & 1gig link on these uplink ports.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/data_sheet_c78-612364.html

Hope this the above information helps.

Neeraj

New Member

WS-C4507RE+96V+ with redundant supervisor

You know, I think you guys may have something confused here.  Juan was asking about the WS-X45-SUP7L-E/2 and Neeraj replied with information on the on the WS-X45-SUP7-E.  The L-E and E are two different products.  The L-E only has two 10 gig ports while the E has 4.  Juan wanted to know if he added the second supervisory engine.  Here is the correct document for the L-E model:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/data_sheet_c78-686325.html

By reading that document it would appear in Figure 2 that when you configure the L-E in resilient mode that you only have one active 10 Gig port and one standby 10 Gig port.

3091
Views
0
Helpful
2
Replies