Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-C4510R-E boot flash command

Hello ,i was putting new image on 4510 just wanted to check if below command in need to put on or is ther some other syntax

boot system flash bootflash:cat4500-ipbasek9-mz.122-53.SG9.bin   <--- is command which i have placed

SW001#sh bootflash:

-#- ED ----type---- --crc--- -seek-- nlen -length- ---------date/time--------- name

1   .D image        FC388696  BD0F08   33 12127880 Feb 11 2009 07:51:44 +00:00 cat4500-ipbase-mz.122-31.SGA8.bin

2   .. image        3CFF21B7 1A23254   32 15016652 Apr 21 2009 04:23:34 +00:00 cat4500-ipbase-mz.122-50.SG1.bin

3   .. image        0EBE4848 29A2654   34 16249728 Oct 8 2013 04:57:10 +00:00 cat4500-ipbasek9-mz.122-53.SG9.bin

17947052 bytes available (43394644 bytes used)

1 REPLY
Cisco Employee

WS-C4510R-E boot flash command

Ross,

I think you should be good to go.

The file is uploaded on to bootflash and you are seeting the correct boot system.

YOu can go ahead with your plan.

REgards

Inayath

162
Views
5
Helpful
1
Replies
CreatePlease login to create content