05-31-2010 08:11 AM - edited 03-06-2019 11:21 AM
WS-C6509 switch supports two models of power supply in the same chassis?
for exemplo :
PS Type Watts A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1 WS-CAC-3000W 1171.38 27.89 - - off
2 WS-CAC-4000W-INT 3795.12 90.36 OK OK on
Note: PS2 capacity is limited to 2940.00 Watts (70.00 Amps @ 42V)
when PS1 is not present
Solved! Go to Solution.
05-31-2010 11:15 AM
Hi,
If you use 2 PSUs with the different wattage in the same chassis then you can not use them in redundant mode which is default.
You can use 2 different PSUs in the same chassis in combined mode only.
Mode info here:
HTH
Reza
05-31-2010 11:15 AM
Hi,
If you use 2 PSUs with the different wattage in the same chassis then you can not use them in redundant mode which is default.
You can use 2 different PSUs in the same chassis in combined mode only.
Mode info here:
HTH
Reza
05-31-2010 03:26 PM
It will work ... as long as the bigger PSU doesn't fail. In regards to the status of the line cards will depend on what they are.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide