Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-C6513 - Is there a way to make sure that a particular line module comes up first

During boot up I want module 12 to come up first because other infrastructure network devices are connected to it.

Is there a way to prioritise the order in which the line modules boot up?

------------------ show module ------------------

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

  1   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JDTW

  2   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1051BQDC

  3   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1108HVWR

  4   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1101DA1H

  5   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1108HVYY

  6   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JDRT

  7    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL1052CQWG

  8    2  Supervisor Engine 720 (Hot)            WS-SUP720-3B       SAL1125S0H1

  9   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JB5G

10   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1049ACJM

11   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1051B46T

12   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JB78

13    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE      SAL10392T6G

2 REPLIES

WS-C6513 - Is there a way to make sure that a particular line mo

Hi,

It may be too difficult but you could swap Module 1 with Module 12.

From memory I think the modules at the top power on first.

It is my understanding that this is also possible to change the order by writing a custom EEM script.

New Member

WS-C6513 - Is there a way to make sure that a particular line mo

Thanks for the reply Sean.

I don't mind trying either option but before I do I have a couple of queries:

1) Is there a document somewhere which confirms that Module 1 will be loaded first.

2) I have never written an EEM script so I would need a guide on how to do it and also what actually needs to be done to force module 12 to load first.

216
Views
0
Helpful
2
Replies
CreatePlease to create content