11-14-2010 12:01 AM - edited 03-06-2019 02:02 PM
Hi
we have 2 WS-4507R-E chassis. these modules are installed on each chassis:
module 3:WS-X4516-10GE
module 2: WS-X4418-GB
both chassis has same IOS:cat4500-entservices-mz.122-52.SG.bin
Problem is: on one of the WS-4507R-E chassis when you install WS-X4418-GB after show modull all it says Faulty on status field. But if you remove this module and installed it on other chassis it is ok.
could you tell me what is the problem?
i attached sh version output from both switches and also sh module all output on both switches
11-14-2010 02:16 AM
Can you try to install the module in the switch it fails in another slot? And
if it still fails capture the output for, "sh log" and "sh diagnostic result module
Regards,
Deepak
12-10-2010 10:06 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: