Are the ports on these line cards configurable for the speed? I need to attach network printers that only have 10/100 TX cards in them and I'm trying to figure out what's the best way to handle this? Configure the port (assuming that's an option)and put a cheaper media converter on OR put a $300+ Gb media converter on. Thanks in advance!
Generally the ports on these modules are not configurable and it depends on the SFP transceiver modules that you are using. However using GLC-T 1000base copper SFP modules you can configure the speed to 10,100,100 or auto. Please have a look at the link below for more info.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...