Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WS-X4515

the WS-X4515 supports 2 GE ports.

can they be used at the same time, to get redundant links?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: WS-X4515

yes, you need to install the GBIC converter on these ports. You have to choose out from WS-5483, WS-5484,WS-5486 GBICs.

http://www.cisco.com/en/US/products/hw/modules/ps5455/products_data_sheet09186a008014cb5e.html

HTH,please rate if it does.

-amit singh

3 REPLIES
Cisco Employee

Re: WS-X4515

Yes, you can use both the GE ports simultaneously if you are using in a single supervisor config on a chassis. If you are using the Sup engine in a redundant sup engine config on 4507R, only the first port of each sup engine is active. the second port of each sup engine is inactive/standby mode.

HTH,please rate if it does.

-amit singh

New Member

Re: WS-X4515

do we need to install GBIC on these 2 GE ports?

Cisco Employee

Re: WS-X4515

yes, you need to install the GBIC converter on these ports. You have to choose out from WS-5483, WS-5484,WS-5486 GBICs.

http://www.cisco.com/en/US/products/hw/modules/ps5455/products_data_sheet09186a008014cb5e.html

HTH,please rate if it does.

-amit singh

164
Views
0
Helpful
3
Replies