Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WS-X6148A-GE-TX is unrecognized in Sup2MSFC2 (Native)

Hi.

I?m trying to get a WS-X6148A-GE-TX going with a 6509 that is using a Sup2MSFC2 < WS-X6K-SUP2-2GE> in Native mode.

The sup2 has 32MB Flash and 128MB RAM.

I?ve used the IOS upgrade adviser to see what the minimum IOS version is that will fit on the Sup2 and that will recognize the WS-X6148A-GE-TX.

The version is : 12.1(27b)E2.

But it fails to recognize the card,

00:00:57: %OIR-SP-3-UNKNOWN: Unknown card in slot 7, card is being disabled

2 REPLIES
Hall of Fame Super Bronze

Re: WS-X6148A-GE-TX is unrecognized in Sup2MSFC2 (Native)

You need to upgrade the memory to 256MB and the flash to 64MB in order to download the 12.2 release since that's the version that supports that card:

From

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/ol_2310.htm#wp1099083

Unsupported Hardware

The following hardware is not supported:

In Release 12.2(27b)E2 and later releases, Supervisor Engine 1.

Supervisor Engine 720

Supervisor Engine 32

Distributed Forwarding Card 3 (DFC3A, DFC3B, DFC3BXL)

WS-X6748-GE-TX 48-port 10/100/1000 RJ-45 Ethernet switching module

WS-X6748-SFP 48-port Gigabit SFP Ethernet switching module

WS-X6724-SFP 24-port Gigabit SFP Ethernet switching module

WS-X6704-10GE 4-port 10-Gigabit XENPAK Ethernet switching module

WS-X6148A-GE-TX, WS-X6148A-GE-45AF 48-port 10/100/1000 Mbps RJ-45 Ethernet switching module

WS-X6148A-RJ-45, WS-X6148A-45AF 48-port 10/100TX RJ-45 Ethernet switching module

WS-X6148-FE-SFP 48-port 100BASE-FX SFP Ethernet switching module

WS-X6148X2-RJ-45, WS-X6148X2-45AF 96-port 10/100TX RJ-45 RJ-45 Ethernet switching module

WS-X6196-RJ-21, WS-X6196-21AF 96-port 10/100TX RJ-21 Ethernet switching module

WS-X6582-2PA Enhanced FlexWAN Module

These FlexWAN port adapters:

PA-A6-OC3MM 1-port ATM OC-3c/STM-1 multimode port adapter, enhanced

PA-A6-OC3SMI 1-port ATM OC-3c/STM-1 single-mode (IR) port adapter, enhanced

PA-A6-OC3SML 1-port ATM OC-3c/STM-1 single-mode (LR) port adapter, enhanced

PA-A6-T3 1-port ATM DS3 port adapter, enhanced

PA-A6-E3 1-port ATM E3 port adapter, enhanced

WS-SVC-IPSEC1 IPsec Virtual Private Network (VPN) acceleration service module

WS-SVC-PSD-1 Persistent Storage Device service module

WS-SVC-MWAM-1 Multi-Processor WAN Application Module

WS-X6624-FXS, WS-X6608-T1, and WS-X6608-E1 voice modules

WS-X6101-OC12-MMF and WS-X6101-OC12-SMF ATM LANE modules

WS-X6302-MSM Multilayer Switch Module

These modules remain powered down if detected and do not affect system behavior.

Community Member

Re: WS-X6148A-GE-TX is unrecognized in Sup2MSFC2 (Native)

well... theres the answer.. thanks for the help

453
Views
4
Helpful
2
Replies
CreatePlease to create content