WS-X6148E-GE-45AT and SUP2T-10G supervisor in 650x-E chassis
Cisco announced EOL for ws-x6148A-GE-45AF linecard and proposed WS-X6148E-GE-45AT. However this card seems not to be supported by the SUP2T-10G supervisor. Which alternative card should I take for this EOL linecard, or can I use the proposed linecard (use extra daughtercard DFC4)?
For short: I'm looking for an alternative linecard for the 650x-E chassis with Supervisor 2T iso 6148-GE-45AF
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...