07-13-2007 11:52 AM - edited 03-05-2019 05:17 PM
I have some confusion:
I have seen posts and configs for c3550 EMI policy based routing.
Although the c3550 SW Configuration guide ( http://cco.cisco.com/en/US/customer/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swiprout.html#wp1260543 ) contains examples for PBR, it also cites laundry list
of unsupported route-map commands, including those used in these same examples.
Does "set ip next-hop" not work or just not covered by warranty?
Thanks for any insight.
07-13-2007 11:25 PM
Hi,
Have you looked at this link ?
http://www.cisco.com/en/US/tech/tk364/technologies_configuration_example09186a00802135d3.shtml
HTH
BR,
Bjornarsb
07-17-2007 12:35 PM
No luck:
I have configured a c3550emi running 12.1(22)EA8a as per the example with sdm prefer extended-match.
I have configured a loopback at 40.40.40.2 on the default gateway at 10.10.10.2.
Initiating a telnet to 40.40.40.2 from 20.20.20.4 connects immediately, apparently ignoring the route-map pbr configured on vlan2.
Have I missed something obvious?
many thanks,
07-17-2007 01:13 PM
My bad:
default routes on the remote gateways pointed back to pbrExample. Telnet session traversed -> 30.30.30.2 -> 30.30.30.1 -> 10.10.10.2.
Still confused as to why "show route-map" and "debug ip policy" show nothing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: