Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

?yet again, pbr on c3550 EMI?

I have some confusion:

I have seen posts and configs for c3550 EMI policy based routing.

Although the c3550 SW Configuration guide ( http://cco.cisco.com/en/US/customer/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swiprout.html#wp1260543 ) contains examples for PBR, it also cites laundry list

of unsupported route-map commands, including those used in these same examples.

( http://cco.cisco.com/en/US/customer/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swuncli.html#wp1014499 )

Does "set ip next-hop" not work or just not covered by warranty?

Thanks for any insight.

3 REPLIES
Bronze

Re: ?yet again, pbr on c3550 EMI?

New Member

Re: ?yet again, pbr on c3550 EMI?

No luck:

I have configured a c3550emi running 12.1(22)EA8a as per the example with sdm prefer extended-match.

I have configured a loopback at 40.40.40.2 on the default gateway at 10.10.10.2.

Initiating a telnet to 40.40.40.2 from 20.20.20.4 connects immediately, apparently ignoring the route-map pbr configured on vlan2.

Have I missed something obvious?

many thanks,

New Member

Re: ?yet again, pbr on c3550 EMI?

My bad:

default routes on the remote gateways pointed back to pbrExample. Telnet session traversed -> 30.30.30.2 -> 30.30.30.1 -> 10.10.10.2.

Still confused as to why "show route-map" and "debug ip policy" show nothing.

144
Views
0
Helpful
3
Replies
CreatePlease login to create content