I have added successful two Cat3560 switch that run HSRP for temporary.
Now they were replaced by two new Cat4506 switch that have the same IP address. But I can add only the active HSRP, not successful for standby HSRP. The message notify is IP address of that switch already in database although I deleted all information related.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...