Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring NetFlow and Dynamic Vulnerability Scanning

Hi All,

Configuring of NetFlow and Vulnerability Scanning are done.Where and how to check the netflow and Vulnerabilty scanning?

Thanks.

2 REPLIES
Silver

Re: Configuring NetFlow and Dynamic Vulnerability Scanning

After enabling network scanning, you can view individual scan reports from Device Management > Clean Access > Network Scanner > Reports. The report shown here is the full administrator report (Figure 13-13). The report shown to end users contains only the vulnerability results for the enabled plugins. (Users can access their version of the scan report by clicking the Scan Report link in their Logout page.)

for more information follow up on this link:

http://www.cisco.com/en/US/docs/security/nac/appliance/configuration_guide/418/cam/m_netsca.html#wp1050604

Community Member

Re: Configuring NetFlow and Dynamic Vulnerability Scanning

Hi ,

I am talking about CSmars configuration but your answer seems NAC configuration.Would u confirm which is related to CS mars or NAC.

188
Views
0
Helpful
2
Replies
CreatePlease to create content