Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Silver

Customising data link up/down rule

Is it possible to somehow filter out specific link up/down messages displayed on MARS? For instance if the syslog message is for a user port, say G1/0/1 I'm not interested in seeing that message, but if its from T1/0/1 then I want to raise the priority of the message as its a key link.

I've looked through the false positive tuning process, it doesnt seem to offer the granuality I'm looking for.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Customising data link up/down rule

I submitted a TAC case on this point a couple of years ago and was told that the rule can be set per device but not per port.  The kind engineer promised to send the idea to product development for possible inclusion in a future release, but I don't know if that has happened.  You may check the release notes for more recent versions of the MARS software than is on your box to see if it has been added.  If not, submit a TAC.  The most likely way to have this feature added is if customers ask for it.

2 REPLIES
New Member

Re: Customising data link up/down rule

I submitted a TAC case on this point a couple of years ago and was told that the rule can be set per device but not per port.  The kind engineer promised to send the idea to product development for possible inclusion in a future release, but I don't know if that has happened.  You may check the release notes for more recent versions of the MARS software than is on your box to see if it has been added.  If not, submit a TAC.  The most likely way to have this feature added is if customers ask for it.

Silver

Re: Customising data link up/down rule

Thanks for the reply, I had sort of come to that conclusion, but thought I'd check.

I'll take a look at the latest release notes, but I dont hold out much hope.

390
Views
0
Helpful
2
Replies
CreatePlease to create content