Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Few short questions

Hello Scott, could you please give me short answers to my questions!

1) Is EPS limit and Netflow limit enforced in software or just recommendation?
2) How do you lock performance of restricted boxes?

3) Are you supporting virtualization yet?

4) Where can I find out amount of RAM different boxes have - it's not in datasheet...

Thank you and best regards!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Few short questions

Martin;

  Here are answers to the questions you posted:

1) The EPS/Netflow numbers are recommendations.  Once the incoming EPS/Netflow exceeds the performance capabilities of the system then CS-MARS will begin dropping events and in extreme cases may start thrashing at high CPU/memory usage.

2) The performance processing for restricted boxes is limited by the license and in turn through the software.

3) There is currently no support for virtualization of the CS-MARS appliance.

4) For currently available appliances:

     210: 8GB
     110/110R: 4GB
     55/25/25R: 2GB

Scott

2 REPLIES
Cisco Employee

Re: Few short questions

Martin;

  Here are answers to the questions you posted:

1) The EPS/Netflow numbers are recommendations.  Once the incoming EPS/Netflow exceeds the performance capabilities of the system then CS-MARS will begin dropping events and in extreme cases may start thrashing at high CPU/memory usage.

2) The performance processing for restricted boxes is limited by the license and in turn through the software.

3) There is currently no support for virtualization of the CS-MARS appliance.

4) For currently available appliances:

     210: 8GB
     110/110R: 4GB
     55/25/25R: 2GB

Scott

New Member

Re: Few short questions

Excellect, thank you!

337
Views
10
Helpful
2
Replies
CreatePlease to create content