MARS Doesn't display attack diagram

[ravisambaji]

Hi Friends,

I have added the devices in the DC to the CS MARS. Following are the devices added and discovered

1) 6509 switch

2) FWSM module

3) IPS Sensor

4) branch router

but the issue is iam not getting the attack diagram in the dash board... it is just blank.

any help is appreciated.

Thanks

Ravi

[Farrukh Haroon]

Attack diagarm is usually visible if both endpoints (source/destination) are available on the map. If the attack involves some internet address the diagram will not display. Try to check any attack which involves source/destination from the local network.

Regards

Farrukh

[phendric]

Check your memory utilization on the Box. This behavior will happen when available memory is too low. I have an open TAC currently due to what appears to be a possible memory leak.

[Mubasher Sultan - 2x CCIE # 20149 (R&S | Sec)]

How can we check the CPU Utilization & Memory Utilization on the box?

Did you get any reply from the TAC about the memory leak?

Appriciate your help.