Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem with adding IPS 6.x to MARS 6.0.1

Hello!

I've recently upgraded our MARS to 6.0.1 and IPS from 5.x to 6.x and after that I have one issue.

Now I can add a "virtual sensor" to the IPS 6.x device. I have the default vs0 virtual sensor, MARS discovers it with device "addition" and then MARS uses the "myIPS/vs0" as a device when displaying events. The problem is that now I receive "Inactive MARS reporting device" concerning the main sensor (not the vs0). I use this event as part of health-monitoring of my devices, but now I can't definitely say if my IPS is active or not.

What is the solution?

Regards, Amir

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Problem with adding IPS 6.x to MARS 6.0.1

You can filter that particular 'reporting device' from the built-in unknown alerting device rule. You can use the not equal to (!=) operator.

Regards

Farrukh

1 REPLY

Re: Problem with adding IPS 6.x to MARS 6.0.1

You can filter that particular 'reporting device' from the built-in unknown alerting device rule. You can use the not equal to (!=) operator.

Regards

Farrukh

122
Views
0
Helpful
1
Replies
CreatePlease to create content