I have an query, I am trying to add about 1000 windows XP hosts onto cisco mars using seed file. From seed file instruction as per cisco mars I have filled all things in seed file, but where can I fill the interface IP setting in seed file.
Since I dont want to use pull method, I dont want to provide any username or password for that.
I had filled in this columns in Seed File :
Column A : windows host name
Column E : WINDOWS
Column F : RPC
Column U : Access IP Address
On importing this into cs-mars, I get an error message "Status: 5 line(s) in the file 'X.csv' have errors. Some of them may have been partially imported. Rest of the error-free lines are successfully imported. Please view backend log for detailed information."
On checking if the device was successfully imported, I find the all details being filled with receive checkbox checked by default but the under the tab "Enter interface information" there is no details filled.
Want to check if incase any windows machine have more than one interface IP how do I add using seed file.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...