Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

stuck in oracle at imaging

Hi everybody,

I'm imaging a 100E with 6.0.2.

When I do a reboot the initial startup gets stuck at "starting oracle:".

Is this a known issue?

Can someone help me with this problem

2 REPLIES
New Member

Re: stuck in oracle at imaging

yes, this just take a while to boot. I have seen it take as long as 90 minutes. Also, if the device fails to perform normall after the ISO upgrade, try making a new DVD on a different PC and start over. I just wnet through this on a CSMARS-50

New Member

Re: stuck in oracle at imaging

I've encountered a similar issue with a 110R.

I had to re-image the box, first had the Oracle Fail with the 6.0.2 DVD I burned, so I used the recovery DVD included with the device, this was successful, however "Starting Oracle" is taking way too long, I let it sit for over 2 hours, the activity light and HD lights flash occassionaly, but it's much too long, I'm restoring again from the included disk, and then will try another Downloaded DVD, but will burn at a slow speed this time.

Anyone else experience similar issues?

152
Views
0
Helpful
2
Replies