I have a 48 port 2960 cisco switch what the things must to connect to the network, and user can connect by this switch?
below is my basic configuration ,
I can ping default gateway and can ping vmps server as well,
but if i connect any pc to it PC not fetching any IP
What should i do additionally to make it work
vmps server 10.178.34.4 primary
vmps server 10.178.34.5
!
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
spanning-tree uplinkfast
no spanning-tree vlan 1
interface FastEthernet0/1
switchport access vlan dynamic
switchport mode access
no logging event link-status
no snmp trap link-status
no cdp enable
spanning-tree portfast
spanning-tree bpdufilter enable
spanning-tree guard root
interface FastEthernet0/48
switchport mode trunk
!
interface Vlan341
ip address 10.178.34.119 255.255.255.128
no ip route-cache
!
ip default-gateway 10.178.34.1
