Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

I have a 48 port 2960 cisco switch what the things must to connect to the network, and user can connect by this switch?

I have a 48 port 2960 cisco switch what the things must to connect to the network, and user can connect by this switch?

below is my basic configuration ,

I can ping default gateway and can ping vmps server as well,

but if i connect any pc to it PC not fetching any IP

What should i do additionally to make it work 

vmps server 10.178.34.4 primary
vmps server 10.178.34.5
!
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
spanning-tree uplinkfast
no spanning-tree vlan 1

 

 

interface FastEthernet0/1
 switchport access vlan dynamic
 switchport mode access
 no logging event link-status
 no snmp trap link-status
 no cdp enable
 spanning-tree portfast
 spanning-tree bpdufilter enable
 spanning-tree guard root

 


interface FastEthernet0/48
 switchport mode trunk
!


interface Vlan341
 ip address 10.178.34.119 255.255.255.128
 no ip route-cache
!
ip default-gateway 10.178.34.1

Everyone's tags (1)
1 REPLY

Do you have a DHCP server?

Do you have a DHCP server? You should statically set a VLAN that will route through your core and get to the DHCP server as well. IP helper address may be needed.

662
Views
0
Helpful
1
Replies
CreatePlease to create content