Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Prepend inbound traffic to other upstream

Dear All

i have 2 upstreams and advertise all same prefixes to both upstreams (A & B).

Due to upstream B have traffic congested so i want some prefix incoming to A upstream instead via B by using command below

---- ---Upstream A------------------

route-policy rp_bgp_chreythom_out

  if destination in pfs_chrey_thom_out then

    pass

  endif

  end-policy

endif

end-policy

prefix-set prepend-ntc

  xx.xx.xx.xx/24,

xx.xx.xx.xx./24,

xx.xx.xx.xx/24,

xx.xx.xx.xx.24

  end-set

neighbor 118.69.xx.xx

  remote-as 23234

  password encrypted ********************

  description *** FPT Chrey Thom ***

  address-family ipv4 unicast

   route-policy rp_bgp_chreythom_in in

   maximum-prefix 525000 90

   route-policy rp_bgp_chreythom_out out

   soft-reconfiguration inbound always

Pls hel to amend this command and big thanks.

thanks

Bora

406
Views
0
Helpful
0
Replies
CreatePlease to create content