Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM OC-3 Multimode in a 7206 using 50/125mm Fibre.

Can this type of interface use 50/125mm Fibre to connect devices over short distances?

CCO says that it needs 62.5/125 but its also says it supports distances of up to 2k.

We wouldn't need any more the 200-300 metres.

Regards,

1 REPLY
Green

Re: ATM OC-3 Multimode in a 7206 using 50/125mm Fibre.

It should work fine. As you suspect, you'll lose some signal due to the core size mismatch, but you should still have enough to make the short haul (and you'll probably still need attenuation).

Good Luck

Scott

148
Views
0
Helpful
1
Replies