The CE should tag the frames with two vlans (one management, one production).
I am planning to use xconnect on sub ATM interfaces to the VPLS on the backbone.
I have 2 issues:
1-the CE1 will tag the frames with a vlan that is different from the VPLS vlan. for example CE1 tag frame with vlan 2004 and xconnect to PE1 in VPLS vlan 4000 at PE2 it is again translated to 2004 but in the response the packet will be forwarded to PE1 with VLAN 4000 and then xconnect to ASR with vlan 4000 and sent in ATM to CE1.
2- is there a way to extract the management vlan from the ATM PVC?
The version of ASR is asr1000rp1-advipservicesk9.03.03.02.S.151-2.S2.bin
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...