Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

atm virtual if

Hello,

probably this is not the correct group for this kind of question but i haven't find another group about atm.

I'm using an LS1010 to interconnect my atm network to DSL Wholese Incumbent Services; it forward me the pvc traffic using vp tunnel. I configure virtual if in this way:

interface ATM1/1/0

description FROM INCUMBENT

no ip address

sonet stm-1

no atm auto-configuration

no atm ilmi-keepalive

no atm signalling enable

atm pvp 28

interface ATM1/1/0.28 point-to-point

description VP 28

no atm auto-configuration

no atm ilmi-keepalive

no atm signalling enable

Now I need to know How much traffic is carried by every sub if.

The only way i found is using the command

show atm interface atM 1/1/0.28 traffic

Interface ATM1/1/0.28

Rx cells: 7780

Tx cells: 68896

5 minute input rate: 0 bits/sec, 0 cells/sec

5 minute output rate: 1000 bits/sec, 2 cells/sec

so i can know the input and output rate.

how can i find the corresponding mib?

I try in CISCO-ATM-VIRTUAL-IF-MIB and CISCO-ATM-TRAFFIC-MIB without success.

somebody can help me?

Thanks in advance

MI

1 REPLY
Bronze

Re: atm virtual if

show interfaces atm 0/0/0 is the command used.TX buffers refers to Number of buffers configured with the atm txbuff command.RX buffers indicates Number of buffers configured with the atm rxbuff command.Refer the follwoing URL for more info

http://www.cisco.com/en/US/products/sw/iosswrel/ps1830/products_feature_guide09186a0080087ae6.html#10861

139
Views
0
Helpful
1
Replies
CreatePlease login to create content