Metro

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

configuration card type 0 4controller e1 0/4/16framing crc4cem- group 0 unframingline code hdb3After this configuration controller still downE1 interface is upWhat will be the issue, anyone suggest ?   

Hello   I have server-mapping in network  segment routing in operator  i want tp know if  server-mapping need a License to install  or not ?   I wait a reply from expert segment routing cisco   Thanks in advance

Morning All,New to the forum and had a question regarding adding a module to a 903. Module is a A900-IMA2ZBeen looking around and saw that you can replace a card without powering it down, but can you add a new card to the system without powering it d...

Hi,   I am new to VPLS. I am trying to test VPLS in the lab initially. My set up is extremely basic at present.   CE1 (3560CG-8) ---- PE1 (3850-12XS-S)----PE2 (3850-12XS-S)----CE2 (3560CG-8)   I have followed the instructions on the following Cisco c...

Hi Team,   I have noticed a weird behaviour on my ASR920 routers trying to configure VPLS   l2 vfi TWC manual  vpn id x bridge-domain x ! interface GigabitEthernet0/0/10 description Test no ip address negotiation auto no keepalive service instance x ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: