Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Can't do selective QinQ on my ME3400?

Hi.

We recently purchased a ME-3400G-2CS-A in order to do some selective QinQ. I have the full Metro IP Access license.

I'm trying to follow the guide, but it isn't working.

Guide shows:

Switch(config)# interface gigabiethernet0/1

Switch(config-if)# switchport mode trunk

Switch(config-if)# switchport trunk allowed 100

Switch(config-if)# switchport vlan mapping default dot1q-tunnel 100

Switch(config-if)# exit

Mine:

pvs1.ixe1(config)#int gi0/1

pvs1.ixe1(config-if)#switchport mode trunk

pvs1.ixe1(config-if)#switchport trunk allowed vlan 2000

pvs1.ixe1(config-if)#switchport vla?

% Unrecognized command

pvs1.ixe1(config-if)#switchport vla?

% Unrecognized command

I've tried the above with all 3 types of port with the same result.

This is the model and IOS itself:

Switch Ports Model              SW Version            SW Image

------ ----- -----              ----------            ----------

*    1 4     ME-3400G-2CS-A     12.2(58)SE2           ME340x-METROIPACCESSK9-M

So why can't I configure this?

1 REPLY
Community Member

Can't do selective QinQ on my ME3400?

Right I see what the problem is. This is a G model and not an EG model

1267
Views
0
Helpful
1
Replies
CreatePlease to create content