I came across a similar issue with Juniper..These juniper routers have ICMP throtling on which gives preference to other processes over ICMP replies..it may also gives preference to not connected IPs when replying to ICMP.
This is the case related to Juniper's rate limiting on the ICMPs. Ideally this is not recommended by Juniper to have icmps act freely. What i can suggest is to limit the number of ICMPs packets using filter limit-icmp under firewall. Please correct me if you feel something was missed.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...